Land Pride ZR52 - Manual (Page 20)

18
Section 3: Adjustments
ZR44 & ZR52 (S/N 472619 & below) Accu-Z Razor ® Zero Turn Mowers 356-059M 4/19/10
Table of Contents
4. Set cutting height at 3 1/4” on the height indicator by
placing the height adjusting stop in the 3” hole, and
turning the height stop so that the flat side is against
the stop handle. Refer to Figure 3-8.
5. Clamp the height adjusting stop against the stop
handle (Figure 3-8). This will assure that the height
will not move during the setting process. Otherwise,
spring pressure from the deck lift springs will tend to
pull the stop away from the handle.
6. Refer to Figure 3-9 & Figure 3-10.
Loosen all nuts on the deck lift threaded rods, and the
hardware on the adjuster (on the right front), until all
the deck lift chains are loose, and the deck is sitting
tightly on all four blocks.
7. Loosen the two nuts on the front of height indicator so
that the foot pedal is free. Refer to Figure 3-11.
Cutting Height
Figure 3-8
Height Adjusting
Stop
Stop
Handle
Chain
Deck Lift
threaded Rod
Nut
Deck Level Adjustment
Figure 3-9
Nut
20668
Deck Level Adjustment
Figure 3-10 19093
Adjuster
Hardware
5/16” Bolt
Jam Nut
Deck Level Adjustment Foot Pedal
Figure 3-11
20667
Nut
Foot Pedal