Land Pride ZR52 - Manual (Page 22)

20
Section 3: Adjustments
ZR44 & ZR52 (S/N 472619 & below) Accu-Z Razor ® Zero Turn Mowers 356-059M 4/19/10
Table of Contents
Anti-Scalp Rollers
Anti-scalp rollers are standard on the Razor Z. These anti-
scalp rollers are designed to minimize scalping when
mowing on rough uneven terrain.
After setting the cutting height, adjust the front anti-scalp
rollers so they extend below the deck but do not contact
the ground. They should always be at least 1/4” to 3/4”
below the deck. With the unit sitting on a flat level surface,
the front wheel position can be adjusted up or down as
needed from 3/4” to 1 3/4” below the blade surface. Move
the front wheels up or down, in 1/2” increments, using the
different axle mount holes in the roller mount bracket.
Refer to Figure 3-13.
Anti-Scalp Roller Adjustment
Figure 3-13
Adjusting
Holes
Anti-Scalp Rollers
NOTE: When the anti-scalp rollers are installed, the
minimum cutting height is 1 1/2” with the anti-scalp
rollers set at 3/4”.