Connecting a sata drive – Lenovo TS200V User Manual
Page 43
6.
Slide the new optical drive into the optical drive bay from the front of the
server until the optical drive snaps into position.
7.
Reinstall the front bezel. See “Removing and reinstalling the front bezel” on
page 19.
8.
Continue at “Connecting a SATA drive.”
What to do next:
v
To work with another piece of hardware, go to the appropriate section.
v
To complete the installation or replacement, go to “Completing the parts
replacement” on page 44.
Connecting a SATA drive
You can connect a SATA optical drive or a SATA hard disk drive to an available
SATA connector on the system board.
To connect a SATA drive, do the following:
1.
Connect one end of the signal cable to the SATA drive and the other end to an
available SATA connector on the system board. See “System-board internal
connectors” on page 14.
Figure 16. Installing the optical drive
Chapter 5. Installing or replacing customer replaceable units
27