Installing a secondary hard disk drive – Lenovo TS200V User Manual
Page 44
2.
Locate an available five-wire power connector and connect it to the SATA drive.
Installing or replacing the secondary hard disk drive
Attention
Do not open your server or attempt any repair before reading and
understanding the “Safety” on page v and the Safety Information book. To
obtain a copy of the Safety Information book, go to:
This section provides instructions on how to install or replace the secondary hard
disk drive.
Installing a secondary hard disk drive
To install a secondary hard disk drive, do the following:
1.
Remove all media from the drives and turn off all attached devices and the
server. Then, disconnect all power cords from electrical outlets and disconnect
all cables that are connected to the server.
2.
Remove the server cover. See “Removing the server cover” on page 18.
3.
Locate the secondary hard disk drive bay. See “Internal drives” on page 16.
Figure 17. Connecting a SATA optical drive
Figure 18. Connecting a SATA hard disk drive
28
Installation and User Guide