Lenovo TS200V - Manual (Page 63)

Padlock
Your server is equipped with a padlock loop so that the cover cannot be removed
when a padlock is installed.
Password protection
To deter unauthorized use of your server, you can use the Setup Utility program to
set a password. When you turn on your server, you are prompted to type the
password. The server cannot be used until a valid password is typed in. Refer to
Chapter 6, “Configuring the server,” on page 49 for more information.
Erasing lost or forgotten passwords (clearing CMOS)
This section provides instructions on how to erase lost or forgotten passwords,
such as a user password.
To erase a lost or forgotten password, do the following:
1. Remove all media from the drives and turn off all attached devices and the
server. Then, disconnect all power cords from electrical outlets and disconnect
all cables that are connected to the server.
2. Remove the server cover. See “Removing the server cover” on page 18.
3. Locate the Clear CMOS /Recovery jumper on the system board. See
“System-board internal connectors” on page 14.
4. Remove all parts and disconnect all cables that might prevent your access to
the Clear CMOS /Recovery jumper.
Note: If your server has a secondary hard disk drive installed, remove the
secondary hard disk drive to access the Clear CMOS /Recovery jumper. See
“Replacing the secondary hard disk drive” on page 31.
Figure 35. Installing a padlock
Chapter 5. Installing or replacing customer replaceable units 47