Lenoxx Electronics CD-160 - Manual (Page 7)

A AA A ATT TT TT TT TTACHING THE SPEAKERS ACHING THE SPEAKERS ACHING THE SPEAKERS ACHING THE SPEAKERS ACHING THE SPEAKERS
NOTE: NOTE: NOTE: NOTE: NOTE: The right and left speakers are NOT NOT NOT NOT NOT
interchangeable. The right speaker
fits only only only only only on the right side (as shown
in FIG. 1). The left speaker fits only only only only only
on the left side.
1.Bring the right speaker to the right side
of the set.
2.Raise the right speaker box about 5
inches above the set. Align the tracks
(rails).
3.Fit speaker over the side rails.
4.When speaker fits over the rails, lower
the speaker as shown in FIG. 2, and make
sure the tabs snap into the speaker
box (locks in the back).
5.Repeat above steps 1 to 4 for the left
speaker box.
6.Carefully unwind the speaker wire from behind each speaker box and plug the right
plug into Speaker Jack R also plug the left plug into Speaker Jack L (as shown in
FIG. 3). Wrap the remaining wire behind each speaker box.
N O T E : N O T E : N O T E : N O T E : N O T E : This set can be used with speaker boxes attached to the cabinet or
separated, just make sure both speaker plugs are plugged into the jacks.
6
FIG.1 FIG.1 FIG.1 FIG.1 FIG.1
FIG.2 FIG.2 FIG.2 FIG.2 FIG.2
FIG.3 FIG.3 FIG.3 FIG.3 FIG.3
TTTTTo remove the speakers, press the lock tab and raise the speakers. o remove the speakers, press the lock tab and raise the speakers. o remove the speakers, press the lock tab and raise the speakers. o remove the speakers, press the lock tab and raise the speakers. o remove the speakers, press the lock tab and raise the speakers.
CD
TAPE
RADIO
SPEAKER
R L
CD
TAPE
RADIO
CD-160S050699 V.2 E