Panasonic DMC-LC70PP - Manual (Page 96)

Playback (advanced)
96
ª When using Windows 98/98 SE
• When using Windows 98/98 SE, install the USB driver before connecting. (When
using Windows Me/2000/XP, Mac OS 9.x and Mac OS X, you do not have to install
the USB driver.)
ª When using Windows 2000 Professional, Windows Me,
Windows 98/98 SE or Mac OS 9.x
The [PTP] (PictBridge) setting is not supported on the following OS’s: Windows
2000 Professional, Windows Me, Windows 98/98 SE or Mac OS 9.x.
Please refer to the following information.
• When connecting the camera to a PC, do not set [USB MODE] to [PTP].
(When the camera is shipped, [Mass Storage] is selected.)
• When connecting to a PC which includes the
above-mentioned OS and setting the [USB MODE] to [PTP],
the messages shown on the right appear on the LCD
monitor of the camera.
The following messages appear for each OS on the display of the PC. Select
[Cancel] to close the window and disconnect the PC.
PTP
USB MODE
OS Message
Windows 2000 Professional [Welcome to the Found New Hardware
Wizard]
Windows Me
Windows 98/98 SE [New Hardware Found] >
[Add New Hardware Wizard]
(When you connect to the PC more than
2 times, only [Add New Hardware Wizard]
appears.)
Mac OS 9.x [Software needed for the USB device
“DMC-LC80, DMC-LC70 or DMC-LC50” is not
available. Would you like to look for the
software on the Internet?]
DMC-LC80.book 96 ページ ２００４年６月１５日 火曜日 午後５時４９分