Panasonic DMC-LC70PP - Manual (Page 100)

Playback (advanced)
100
Connecting to a Printer
By connecting the camera directly to a printer supporting PictBridge or USB
DIRECT-PRINT via the USB connection cable (supplied), you can select the
pictures to be printed or start printing.
• DMC-LC80/DMC-LC70 is illustrated
below as an example.
A AC adaptor (optional, DMW-AC1)
B USB connection cable
1 Turn the camera on and then set
the [USB MODE] to [PTP]
(PictBridge) or [Mass Storage]
(USB DIRECT-PRINT). (P95)
2 Turn on a printer.
3 Connect the camera to the printer
via the USB connection cable
(supplied).
• Align the 2 mark on the USB
connection cable and the 1 mark on
the [DIGITAL] socket.
¬Suggestions/Tips ¬
• Ask the manufacturer of the printer
about the corresponding models.
(Read the printer operating
instructions too.)
• If the remaining battery power
becomes low during communication,
the power indicator blinks and the
alarm beeps. In this case, stop the
communication, because the data may
be destroyed. Then turn the camera
off and use the following power
source.
• New batteries
• Charged batteries
• AC adaptor (optional, DMW-AC1)
• When connecting to a printer, we
recommend using the AC adaptor
(optional, DMW-AC1) as the power
source.
• Set the paper size and print quality
with the printer. (Read the printer
operating instructions.)
• Disconnect the USB connection cable
after printing.
• Do not use any other USB connection
cables except the supplied one.
A
B
DMC-LC80.book 100 ページ ２００４年６月１５日 火曜日 午後５時４９分