Pioneer HANDWRITING DEVICE PDK-50HW3 - Manual (Page 11)

11
1. Specifications
1.4 Name and Function of Parts & Pin Layout
1.4.1 Plasma display monitor (PDP-504CMX/PDP-50MXE1/PDP-50MXE1-S)
For information on the plasma display, refer to “Name and Function of Parts” in the Technical Manual supplied with the
PDP-504CMX.
1.4.2 Handwriting device (PDK-50HW3)
a) Scan device
PEN
NORMAL
Rear side
of unit
Mode selector switch
Set the mode switch in accordance with
whether you will use the special pen or
other device to input characters and lines
on the screen.
PEN Mode:
In this mode, the
special accessory
pen can be used to write on the screen.
Using the special pen allows the drawing
of more clearly delineated characters and
lines.
NORMAL Mode:
In this mode, your
finger or other
object can be used to write on the screen.
This mode will produce lower screen
definition, however, compared to drawing
with the dedicated input pen.
Power indicator
(Lights green when ON)
IR transmitting filter
b) Special pen
¶ Name and function of parts
If pen operation becomes difficult:
The pen may fail to operate properly if the holes in rear
end of pen are blocked. Also, the pen may begin
operating erratically when the battery becomes depleted.
In this event, change the battery at your earliest
opportunity.
Confirming Battery Life:
When the small button is depressed fully, an LED
indicator will light. If the indicator fails to light, or lights
only dimly, the battery is depleted and should be
replaced.
¶ External dimension drawing
186
22
ø
18.5
Note:
When the power switch is first turned on, the power
indicator will flash orange; while the indicator is
flashing, do not touch the screen, since the unit is
initializing its internal settings
Tip
Cap
Pen tip
(corresponds to left mouse button)
LED indicator
Battery cover
Large button
(corresponds to right
mouse button)
Small button
(The function corresponding to middle
mouse button can be assigned using
the driver software.)
Holes in rear end of pen