Pioneer HANDWRITING DEVICE PDK-50HW3 - Manual (Page 21)

21
3. Installation Procedures
3.4.2 Screen burning
Refer to “Screen Burning” in the Technical Manual supplied with the plasma display.
3.5 Installing the Driver
1. Install CBdrvU.
Refer to “Installing the CBdrvU (Ver. 2.0) Driver” on page 25.
2. Reboot the computer.
3.6 Connecting a Scan Device to a Computer
Connect the unit’s USB cable to the computer. (Connect to the USB1.1 or USB2.0 port.)
USB cable
Computer
Note:
When connecting a USB hub, use only self-powered types (with AC outlet power connection) with the capacity to provide 500mA
current.
When a USB cable is connected, the accompanying screen message will appear:
The power indicator will flash orange, and then flash alternately in green and orange. Do not touch the screen while the
indicator is flashing, since automatic settings are being made during this time. There are no requirements regarding
power on/off operation.