Panasonic PANAFAX DX-2000 - Manual (Page 207)

205
Directory Sheet The list that contains the station names that are programmed into your unit.
DNS (Domain Name Server) The purpose of the DNS is to store records containing domain information,
such as Fully Qualified Domain Names (FQDN) and translate them to
TCP/IP addresses.
Domain Name A unique name that identifies an Internet site. Domain Names always have
2 or more parts, separated by dots. The part on the left is the most
specific, and the part on the right is the most general.
DTMF (Dual Tone Multi-
Frequency) Dialling method that sends a different set of frequencies for each digit of
the telephone keypad. Commonly refers to touch tone dialling.
ECM (Error Correction Mode) The ability to correct transmission errors as detected during the
transmitting phone call.
Email Address The address for sending and receiving data by email. It consists of User
name, Sub-domain name and Domain name.
End receiving station In a relay network, the final station designated to receive the document.
Energy-Saver Mode Saves energy by consuming less power than when in standby mode by
turning off the fuser unit after the specified time.
Ethernet A very common method of networking computers and equipment in a LAN.
Ethernet can handle up to 100 Mbps and can be used with almost any kind
of computer.
FAX Forward The ability to forward all incoming faxes to the registered One-Touch or
ABBR No. station.
FAX Parameter List The list that contains the home FAX parameters settings that you have
programmed into your machine.
F.C.C. Federal Communications Commission. The U.S. Government organization
that regulates communications originating or terminating in the United
States.
File A task that has been stored into the memory of your unit. Examples are
deferred transactions.
Fixed print reduction The method that allows you to determine one reduction rate, such as 75%,
for all incoming documents.
FUNCTION The control panel key that will be utilized to begin an operation or
configuration of a feature.
G3 mode (Group 3) Refers to the standards and transmission capabilities of the current
generation of facsimile machines.
Group dialling The ability to program many telephone numbers and/or email addresses
into a single station so that many locations can be dialed in sequence
utilizing a single keystroke.
HALFTONE A scanning technique to distinguish levels of gray from black and white.
Your machine can detect up to 64 levels of gray in halftone mode.
Handshaking The exchange of a group of control signals that communicate between the
transmitter and receiver. These signals determine the condition at which
communication can occur.
Glossary
9