Panasonic PANAFAX DX-2000 - Manual (Page 95)

93
Manual Number Dialling
To dial the telephone number manually, follow the steps below. (see Note 1) (see Note 2)
(see Note 3)
1
Set document(s) face down.
2
Make sure that the MEMORY lamp is on.
If not, press
to set “On”.
3 Enter a telephone number from the keypad.
Ex:
4
The document(s) begin to store into memory with a file
number.
Then starts dialling the telephone number immediately after
storing the first page. (See Note 3)
The remaining page(s) continue to store into memory.
Note:
1. If you need a special access number to get an outside line, dial it first then press to enter a pause
(represented by a "-") before dialling the full number.
Ex : 9 PAUSE 5551234
2. If you are using Pulse dialling and you wish to change to Tone dialling in the middle of dialling, press
(represented by a "/").
The dialling mode will be changed from Pulse to Tone after dialling the digit "/".
Ex : 9 PAUSE TONE 5551234
3. This feature is called “Quick Memory Transmission”. If you wish to store All the document(s) into memory first
before transmitting, change the Fax Parameter No. 082 (QUICK MEMORY XMT) to “Invalid”. (See page 74)
ENTER STATION(S)
THEN PRESS START 00%
MEMORY
MEMORY
5 5 5 1 2 3 4
TEL. NO.
5551234 ❚
START
* STORE * NO.001
PAGES=001 01%
* DIALLING * NO.002
5551234
PAUSE
TONE
Sending Documents via Telephone Line
4