Pentax *ist IST DS - Manual (Page 116)

114
5
F
uncti
on Re
ferenc
e
4
Use the four-way controller (3)
to select [K (Manual)].
5
Press the four-way controller
(5).
The message screen appears.
6
Fully display a white or gray sheet of paper in the
viewfinder under the light to adjust white balance.
7
Press the shutter release button fully.
[OK] appears on the LCD monitor when setting is successful.
[NG] appears on the LCD monitor if setting is not successful.
8
Press the 4 button.
• No image is recorded when the shutter release button is pressed to adjust
the white balance.
• Press the { button again when setting is unsuccessful to set again.
• You can set the range to measure white balance when setting manually.
White balance is measured using the entire screen using multi-segment
metering (p.130) if [Entire screen] is selected for [Man. WB Measurement] in
[A Custom] menu (p.101). White Balance is only adjusted in the spot
metering area (p.131) if [Spot Metering Area] is selected.
OK OK OK
White Balance White Balance
OK
White Balance
Manual Manual
Adjust Adjust
Manual
Adjust
Manual Manual
White Balance
White Balance
Point camera at subject Point camera at subject
Press the shutter Press the shutter
release button release button
Manual
White Balance
Point camera at subject
Press the shutter
release button