Panasonic KX-FPG176 - Manual (Page 50)

50
Receiving Faxes
Pager call - when the unit receives a fax or !
voice message !
This feature allows your unit to call your pager when your unit receives a fax document or an
incoming voice message.
1 Press p .
Display:
2 Press # , then 70 .
3 Press + or - to select “ON”.
● If this feature is not required, select “OFF”.
4 Press w .
5 Enter your pager number up to 30 digits.
Example:
6 Press
w
.
7 Enter your pager access code up to 10 digits
if required.
Example:
PIN=12345678
NO.=12025551234
PAGER CALL
MODE=ON
[±]
PAGER CALL
MODE=OFF
[±]
SYSTEM SET UP
PRESS NAVI.[
I H ]
Note:
● If you have subscribed to a Caller ID service,
instead of the message you entered in
step 8, your pager will display the caller’s
telephone number, followed by “11” or “22”.
11: When your unit receives a voice message.
22: When your unit receives a fax document.
● If you have not entered a message in step 8,
your pager will only display “11” or “22”.
8 Press w .
● The default code 07734 will
show “Hello!” on your pager.
● If you want to change this
message, enter your message
up to 30 digits.
9 Press w .
● The unit will dial the stored
number.
10 Check that your pager received
the pager test call.
11 Press NO .
PAGER TEST
MSG.=07734
Extension telephone !
To the same line
Extension telephone
Note:
● You can change the fax activation code in
feature #41 (p. 72).
If you use the fax machine with an extension telephone, you can receive fax documents using
the extension telephone. You do not have to press
j on the fax machine.
Important:
● Use a touch tone telephone as the extension telephone and enter the fax activation code firmly.
1 When the extension telephone rings, lift the
handset of the extension telephone.
2 When:
— document reception is required,
— a fax calling tone (slow beep) is heard, or
— no sound is heard,
press
*9 (pre-selected fax activation
code) firmly.
3 Hang up the handset.
● The fax machine will start reception.