PoGo Products T1 - Manual (Page 10)

9
1.2 Basic Setup
1.2.1 Video Setup
IMPORTANT! The MEDIAGATE T1 video output mode and TV set input mode must be on the same setting.
ü If you cannot see a normal screen after connecting the video cable, please check the following:
1. “TV “– Switch to Video Input Mode: Turn on TV and switch to video input mode, same as video connection. See TV users manual
for more info.
2. “MEDIAGATE T1” – Switch to Video Output Mode: Press [VIDEO] button repeatedly. Whenever [VIDEO] is pressed, the video
output signal is changed.
3. After you see a normal screen, you must save the video configurations of MEDIAGATE T1.
TV Video
Input Mode
MEDIAGATE T1
Video
Output Mode
Connection Jack
of TV, MEDIAGATE
T1
Video Cable Type
TV Out: NTSC C/S-Video
(HD Component OFF)
Normal Video
TV Out: PAL C/S-Video
(HD Component OFF)
CVBS or Composite Jack
(Generally Yellow Jack)
Yellow RCA Cable
(Supplied)
TV Out: NTSC C/S-Video
(HD Component OFF)
S-Video
TV Out: PAL C/S-Video
(HD Component OFF)
S-Video Jack
S-Video Cable
* Black rounded
TV Out: NTSC C/YPbPr
(HD Component OFF)
Component 480i
TV Out: PAL C/YPbPr
(HD Component OFF)
Component 480p HD Component Out On 480p
Component 720p HD Component Out On 720p
Component 1080i HD Component Out On 1080i
Component 3 Jack
* Y (Green), Pb(Blue), Pr(Red)
Component Cable
* Y (Green), Pb(Blue), Pr(Red)
ü NTSC, PAL: Standard of TV Output. Select the proper setting for using in your country.