PoGo Products T1 - Manual (Page 40)

39
3. Use as External USB HDD
3.1 Insert Hard Disk (for drive-less MEDIAGATE T1 version)
ü Use 3.5” IDE Hard Disk for data storage. Section 1.1 is for drive-less MEDIAGATE T1 models. Please skip to 3.2 if
you have the MEDIAGATE T1 with built-in drive.
ü Hard Disk should be “Master.” However, if the Hard Disk supports “Single” mode, you should set it to
“Single“ mode.
ü For users installing a new drive: All hard-disk drives used with MEDIAGATE T1 need to be formatted in FAT32. If
you are unsure about formatting, please consult with your PC tech for further formatting information.
1. Unscrew the 4 corner screws and open by sliding
the side cover in the direction pointed by the arrow. 2. Connect Power and IDE connector to Hard
Disk.
3. Close by sliding the side cover in the direction
pointed by the arrow. 4. Finish assembly by reinstalling four corner
screws.