Panasonic CX-DH801U - Manual (Page 17)

33
CX-DH801U
6
English
32
CX-DH801U
5
English
DVD Changer Basics
DVD Changer Basics
(Continued)
Loading and Removing a Disc
❑ To Load a Disc
q Place the disc magazine with the direction arrow facing
upward, and pull out trays fully one after another from
the magazine.
w Place a disc on the tray.
e Push the tray straightforward into the magazine until it
clicks in position (See caution above).
Note:
¡Be careful not to insert more than one disc on a single
tray to protect the unit from any unexpected troubles.
¡Please insert discs so that the same types of discs are
arranged successively, as far as possible. Discontinuous
arrangement of the same type discs may cause the unit to
take a long time to change discs.
¡Be sure to use the magazine and the trays supplied with
the unit as an accessory (VYQ3174). Any other maga-
zines can not be used.
¡Never use protection film or stabilizer commercially avail-
able as a disc accessory for the unit because it may cause
trouble.
¡Do not use irregularly-shaped discs. Failure to observe
this may cause malfunction.
❑ To Remove a Disc
Pull out trays from the magazine to the stopper position, and
take a disc from each of them by hand.
Be careful not to allow the disc to drop to the ground while tak-
ing it out.
Note: Carefully handle the magazine since discs may be disen-
gaged and come out, if the magazine is placed with its disc-
inserting port facing downward.
Magazine Tray
Disc with the labeled side
q
w
e
❑To Load the Magazine
q Slide the door to the right until it is fully open with a click.
❑To Remove the Magazine
q Open the door.
w Press the eject button (u).
The magazine will eject automatically.
e Pull the magazine straight in the arrow direction until it comes off
the unit.
r Close the door.
q
w
q w
e
e r
Eject button (u)
Loading and Removing the Magazine
Magazine Inserting
Direction Arrow
Caution: Insert disc trays into the magazine firmly until they click. Failure to do so may cause disc clogging in
the DVD changer unit or a malfunction of your DVD changer.
e Close the door fully until you hear a click.
w Check the unit for its top and magazine inserting direction, and
carefully push the magazine straightforward into it until you hear a
click.
Note:
• When inserting the magazine, follow the sign marked on the maga-
zine for the inserting direction.
• Make sure that all disc trays are loaded into place before magazine
insertion.
Caution:
• Be sure to keep the disc unit door closed to prevent dirt and dust
from getting into the unit and causing possible malfunctions.
• The magazine cannot be inserted when a tray is not loaded into
place. In this situation, forced insertion may cause damage to the
unit and magazine.
Note: The disc trays of the DVD changer are
easy to remove from the magazine. Please watch
out the trays are not slipped out from the maga-
zine when installing a disc.
If one of the trays is slipped out and removed,
insert the disc tray into the magazine gently until
a click is felt.
Note: Please wait for 10 seconds or more after connecting the battery cord to insert the disc magazine. Failure to observe
this may cause a disc loading error.