Pentax 645N2 - Manual (Page 47)

45
ADV
ANCED OPERA
TIONS
3 4 *
3. Set the desired f-stop.
4. The f-stop that you have selected and appro-
priate aperture indication determined by the
camera can be seen in the viewfinder when
the shutter release button is depressed
halfway.
• The approximate aperture indication appears in
the viewfinder. It may not the same indication as
you select the lens aperture ring especially when
the A645 150mm f/3.5 or A 645 45-85mm Zoom
f/4.5 is attached.
* Exposure Warning
If the subject is too bright or too dark, the selected
shutter speed will blink in the viewfinder and on the
LCD panel as a warning as shown. When the sub-
ject is too bright, choose a smaller aperture, if avail-
able; when it is too dark, choose a larger aperture,
if available. When the shutter speed indication
stops blinking, you can take the picture. If both
shutter and aperture blink, it means that the expo-
sure is out of metering range, unable to obtain a
correct exposure even if the aperture is adjusted.
Select a darker subject if it is too bright, or use a
flash if it is too dark.
22 16 8 4 22 16 8 4
f t m 1 0 1 5
A 22 16 11 8 5.6 2.8