Pioneer DEH-P6450 - Manual (Page 30)

Initial Settings
En 30
07
Section
07
Adjusting initial settings
Initial settings lets you perform initial set up of
different settings for this unit.
1
FUNCTION display
Shows the function status.
1 Press SOURCE and hold until the unit turns
off.
2 Press FUNCTION and hold until time
appears in the display.
3 Press FUNCTION to select one of the initial
settings.
Press
FUNCTION repeatedly to switch between
the following settings:
CLOCK — FM — AM — WARN — AUX — DIM —
BRIGHT — SW — TEL
Use the following instructions to operate each
particular setting.
• To cancel initial settings, press
BAND/ESC .
• You can also cancel initial settings by holding
down
FUNCTION until the unit turns off.
Setting the time
This is used to set the time on the unit’s clock
display.
1 Press FUNCTION to select the CLOCK .
Press FUNCTION until the time appears in the
display.
2 Select the portion of the time display you
wish to set with
2/3.
Pressing
2/3 will select a portion of the clock
display:
HOUR — MINUTE
As you select portions of the clock display the
portion selected will blink.
3 Select the correct time with
5/∞.
Pressing
5 will increase the selected hour or
minute. Pressing
∞ will decrease the selected
hour or minute.
Setting the FM tuning step
The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
1 Press FUNCTION to select FM .
Press FUNCTION repeatedly until FM Step
appears in the display.
2 Select the FM tuning step with
2/3.
Pressing
2/3 will switch the FM tuning step
between 100 kHz and 50 kHz. The selected FM
tuning step will appear in the display.
Note
• If seek tuning is performed in 50 kHz steps,
stations may be tuned in imprecisely. Tune in
the stations with manual tuning or use seek
tuning again.
1