Pioneer DEH-P6450 - Manual (Page 32)

En 32
07
Section
Initial Settings
Selecting the brightness
You can select the display brightness. Initially
this mode is set to 12.
1 Press FUNCTION to select BRIGHT .
Press FUNCTION repeatedly until Brightness
appears in the display.
2 Select the desired brightness with
2/3.
• The display shows 0 – 15 .
Switching the rear output setting
This unit’s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker or subwoofer connection. If you
switch the rear output setting to the subwoofer,
you can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
• If you connect a subwoofer to the rear output,
set the output setting to subwoofer.
• Even if you change this setting, there is no
output unless you switch the subwoofer out-
put on (refer to Using subwoofer output on
page 28).
• Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting.
1 Press FUNCTION to select SW .
Press FUNCTION repeatedly until FRT+REAR
appears in the display.
2 Select full-range speaker or subwoofer
with
2/3.
Pressing
2/3 will switch between
FRT+REAR
(full-range speaker) and FRT+SW (subwoofer)
and that status will be displayed.
Switching the Telephone
Muting/Attenuation
Sound from this system is muted or attenuated
automatically when a call is made or received
using a cellular telephone connected to this
product.
1 Press FUNCTION to select TEL .
Press FUNCTION repeatedly until Telephone
appears in the display.
2 Switch the telephone muting/attenuation
with
2/3.
Pressing
2/3 will switch between
Telephone
:ATT (attenuation) and Telephone :MUTE (mut-
ing) and that status will be displayed.
07