Precor EFX 532 - Manual (Page 17)

page 17
C O M M E R C I A L P R O D U C T S D I V I S I O N
To access the Club mode, the following must occur:
❑ Check to be sure that the EFX is turned ON.
❑ Check that the Precor (or club) banner appears on the display.
❑ Press the appropriate key sequences.
Important: To access Club mode, press Reset while the Precor banner is dis-
played. Within 1/2 second, begin pressing the key sequences. If the system does
not detect a key press (within 1/2 second) after Reset, it returns to the banner.
Once you begin entering a key sequence, each key must be pressed within 4
seconds of the other or the Precor banner reappears and you have to begin again.
Note: The touch sensitive keys can be gently pressed and held to view several
selections. The longer the key is held down, the faster the numbers scroll past.
Important: Remember to begin at the Precor banner. After pressing the Reset
key, you must press the next key in the sequence within 1/2 second, or the
Precor banner reappears and you have to begin again.
The display console keys that you need to press to select the units of measure, set
the maximum workout and pause times, or set the scrolling speed are as follows:
Reset: Quick Start, Resistance ▼ , Quick Start, CrossRamp ▲ , Quick Start,
Resistance ▼ , Quick Start
▼▲ lets you scroll through the
various selections that appear.
Enter saves the information being
displayed and moves to the
next aspect of the program.
Reset exits Club mode and
displays the Precor banner.
Display key functions within the Club Mode
DETERMINING THE UNITS OF MEASURE
Two different units of measure can be selected, Metric or U.S. standard. Make
your selection using the ▼▲ keys. Press Enter once the correct unit is displayed.
Note: Anytime you wish to exit the Club mode, press the Reset key. Any
previous display attributes that you selected by pressing Enter are saved and
recorded in memory. If no key press is detected within 2 minutes, the banner
reappears because no entry occurred.