Polaroid P75 User Manual
Page 10
1.4
The following will guide you through the
installation of your
P75
printer.
P
PR
RIIN
NT
TEER
R
IIN
NSST
TA
ALLLLA
AT
TIIO
ON
N
C
CA
AU
UT
TIIO
ON
N :: Limit AC power supplied to the
P75
Printer to 110 - 230 V AC, 60 - 50 Hz for an
associated 800 mA - 400 mA. Limit excess current
draw to 16 amps or less, using an associated
circuit breaker or other such device. Never operate
the printer in a location where operator, computer,
or printer can get wet. Personal injury could result.
The printer must be connected to an earthed
electrical power supply and properly protected
against electrical surges and grounding faults.
1.
Place the printer in a location that allows easy
access to all sides. The printer should never be
operated while resting on its side or upside
down.
2.
Place the printer’s power switch in the OFF (0)
position.
3.
Insert the power cable to the printer power socket
and attach to grounded electrical socket of the
proper voltage and type.
4.
Attach interface cable to printer and computer
and then secure.
C
CA
AU
UT
TIIO
ON
N::
Intermittent or unpredictable
operation may occur from unsecured connectors.
If damaged, the power cable must be replaced by
an exact equivalent.
5.
Switch power on.