Panasonic WV-CS854B - Manual (Page 48)

-48-
Notes:
• Defaults are marked with *.
• BP stands for Bit Position.
• Full duplex is not available in a daisy chain
connection. (Panasonic system controllers only)
3. Assemble the Camera
Reverse the disassembly procedure. Take care not to
cut any cables.
Precaution: Be sure to select a ceiling board strong
enough to support 4 times the total weight of the
camera.
a. Sideway Cable Exit
Prepare a cutout in the diecast case and decoration
cover as shown in the following figures.
Cutout in Diecast Case
Cutout in Decoration Cover
Note: Remove sharp edges to protect the cables.
b. Top Cable Exit
Prepare a hole in the ceiling board to run the cables.
1. Mark the mounting holes on the ceiling, using the
removed camera mounting base as a template.
2. Fix the camera mounting base to the ceiling with
four screws (not provided, M4).
RS485 Setting
The 4-bit DIP switch is used for RS485 termination.
Full duplex (4 line) *
BP 2
BP 1 Function
Switch
position
Function
Switch
position
ON
OFF
Termination ON
Termination OFF *
1 2 3 4
ON
4-bit DIP SW
BP 3 BP 4
ON ON ON
OFF OFF OFF
Half duplex (2 line)
Marking