Panasonic WV-CS854B - Manual (Page 49)

-49-
3. Hook the fall prevention wire on the camera
mounting base.
Cautions:
• Use the supplied dust protection sheet if the camera
mounting base is liable to be exposed to a dusty
atmosphere. Remove the cover from the dust
protection sheet, then stick the sheet on the camera
mounting base.
• Remove the sheet before mounting the camera on
the base.
• While the camera is separated from the base, keep
the camera in the supplied polyethylene sack.
4. Mount the camera on the camera mounting base
and rotate the camera clockwise.
5. Tighten the fixing screw M3 (provided).
Notes:
(1) Tighten the camera fixing screw with a
screwdriver.
(2) Follow the instructions given here to ensure that
the camera and camera mounting base are
installed safely.
(3) When removing the camera from the camera
mounting base, loosen and press up the camera
fixing screw (M3) with a screwdriver.
6. Fix the decoration cover to the camera mounting
base.
a. Sideway Cable Exit
Pass the cables through the cutout made in the
diecast case and decoration cover.
b. Top Cable Exit
Push the decoration cover against the camera
mounting base.
Be sure to match the wire with the fall
prevention wire fixing angle as shown below.
Fall prevention
wire fixing angle
Ring of the
fall prevention
wire
15
°