Panasonic MW-10 - Manual (Page 21)

21
RQT9522
Ref
erence
Operations
Troubleshooting guide
Before requesting service, make the following checks. If you are in doubt about some of the check points, or if the remedies
indicated in the chart do not solve the problem, refer to “Customer Services Directory (United States and Puerto Rico)” on page 23.
This unit may become hot if used for a long period of time, however, this is not a problem for use.
Common problems with the whole system
All operations are ignored. Press [POWER8] of the main unit for more than 10 seconds to turn the unit off. If the
problem persists, do the following operations and return the settings to the factory defaults.
1. Remove the AC power supply cord once. Then connect the AC power supply cord
while pressing down [POWER8] of the main unit.
2. Press and hold [POWER8] of the main unit until “The settings have been reset.”
appears on the display.
When the unit is turned on,
“Please wait.” is displayed for a
long period of time.
When photos are present in the internal memory or the SD card has been inserted, it
may take long time for the unit to become operable after it is turned on.
Booming noise occurs during
audio playback.
There may be the AC power supply cord of another device or fl uorescent light near this unit.
ˆ Keep the electric appliances as far away as possible from this unit.
CD
The display does not change even
after the CD is inserted.
Playback does not start even after
the play button is pressed.
A nonstandard disc was inserted. (¼P4)
There was extreme temperature difference, such as when carrying the unit from the cold
place to the warm place. Dew condensation might have occurred on the lens.
ˆ Wait approx. 1 hour before use.
Specifi c parts are not played normally. ˆ Wipe the CD with a soft cloth. (¼P4)
The display part is not closed properly. ˆ Check if the CD is set at the correct position. (¼P6)
SD
Data on the SD card cannot be read. ˆ Use the SD card, fi le format and folder hierarchy compatible with this unit. (¼P5)
Photos cannot be played or
edited.
ˆ Insert the SD card compatible with this unit. (¼P5)
ˆ Insert the SD card correctly. (¼P6)
ˆ Cancel the write protection switch if it is on the “LOCK” side. (¼P4)
iPod
The iPod is not recognised even if
connected.
ˆ Check if the iPod is compatible with this unit. (¼P5)
Video playback becomes
impossible on the iPod.
ˆ Confi rm the iPod video settings.
The display of the iPod video
playback shows an unexpected one.
iPod videos cannot be played back. ˆ Check your iPod version.
Radio
FM and AM broadcasts cannot be
received properly.
Noise and sound distortion are
excessive.
“ ” does not light up.
ˆ Connect the FM indoor antenna or AM loop antenna. (¼P8)
ˆ Change the setting location or direction of antennas.
ˆ Separate the antenna wire and AC adaptor as far as possible.
ˆ If the transmitting location is far or there is a big building or mountain near the unit,
use an outdoor antenna. (¼P13)
TV, VCR, PC or BS tuner may be on. Or the mobile phone may be charged near the unit.
ˆ Turn each device off or keep those devices as far away as possible from this unit.
Remote control
Cannot operate the remote
control.
ˆ Insert (+, –) of battery correctly. (¼P7)
ˆ Replace with the new battery. (¼P7)
ˆ If the remote control mode on the main unit does not match the one on the remote
control, match the mode of the remote control to the one of the main unit. (¼P18)
ˆ If the display is opened, close it.
Another device does not operate
properly when using the remote
control of this unit.
The unit does not operate
properly when using the remote
control of another device.
ˆ Change the remote control mode of this unit so another device does not interfere with
this unit’s operation. (¼P18)
„
„
„
„
„
„
Installation of this unit /
Tr
oub
leshooting guide
Using with y
our PC