Panasonic MW-10 - Manual (Page 8)

8
RQT9522
Connecting antennas and power source
1
3
2
A
G
H
I
B
CD
E
F
1. Connect the FM indoor antenna.
Insert fi rmly to the end.
Receive broadcast signals (¼P12) after connection
and fi x the end of the antenna using a tape (A) at the
least noisy position.
2. Connect the AM loop antenna.
B Insert into the groove. Insert fi rmly until it clicks.
C Red D White E Black
F Use a Phillips-head screwdriver, etc. Do not screw
too tightly. Otherwise, the screwdriver goes around in
circle and cannot be fi xed.
Receive broadcast signals (¼P12) after connection
and place the antenna at the least noisy position.
Do not use any other AM loop antennas except the
supplied one.
3. Connect the AC power supply cord.
G AC adaptor
H AC power supply cord
I To household AC outlet (Connect last.)
Note
While using this unit, the AC adaptor may become a little
hot. This is not a malfunction.
The included AC power supply cord and AC adaptor
are for use with this unit only. Do not use it with other
equipment.
Do not use AC power supply cord and AC adaptor from
other equipment with this unit.
•
•
•
•
•
•
•
When the Demo function (¼P18) is activated
When connecting the AC
power supply cord, the unit
is automatically turned on
and the screen shown at
right appears.
Start Demo
Disable the Demo function
When not using the demo function ¼ , press [e, r] on the
remote control to select the setting to disable it, and then
press [OK].
¼ With the demo function, simple explanations about the
unit’s functions are displayed on the display part.
If it is set to Enable or operation is not performed for
more than 2 minutes, the demo function is activated. If
the unit is operated, the demo function is canceled and
the standard screen appears.
You can switch the demo function to Enable/Disable by
pressing [DISPLAY MODE] on the main unit for approx. 2
seconds while audio is stopped.
•
•
To remove the AC power supply cord
Turn the unit off.
After the screen completely turns off, pull out the AC power
supply cord.
About speakers
These speakers do not have magnetic shielding. Do not
place them near televisions, personal computers or other
devices easily infl uenced by magnetism.
You can damage your speakers and shorten their useful
life if you play sound at high levels over extended periods.
When the sound is distorted or the sound quality is
adjusted, turn down the volume even in the normal use.
(Failure to do so may cause the speakers to be damaged.)
The speaker nets cannot be removed.
„
„
•
•
•
•
Back of
product