Panasonic DIGA DMR-EZ27 - Manual (Page 68)

68
RQT8851
General Issues
Operation
Page
Cannot operate the TV or Set
Top Box with the unit’s remote
control. Change the manufacturer code on the remote control. • 58
Select TV or Set Top Box mode on the remote control. • 58
The remote control doesn’t
work. The remote control code is wrong. Change to the correct code. • 66
The batteries are depleted. Replace them with new ones. • 5
Point the remote control at the remote control sensor on the main unit. • 5
Remove obstacles between the remote control and main unit. • −
Remove dust from the transmission window and the unit’s sensor. • −
Colored glass may obstruct the signal reception/transmission. • −
Don’t place the signal sensor in direct sunlight or in areas that may be
subject to sun exposure. • −
It may be necessary to set the code on the remote control again after
changing the batteries. • 66
It may be necessary to set the manufacturer code again after
changing the batteries. • 58
The unit is on but cannot be
operated. Some operations are prohibited by the disc. • −
The unit is warm (“U59” appears on the unit’s display). Wait until “U59”
disappears. • −
One of the unit’s safety devices may have been activated.
Reset the unit as follows:
Press [POWER 8] on the main unit to switch to off.
If the unit doesn’t switch to off, reset the unit (
➔ 66, “To restore the
unit if it freezes”).
• −
“U88” is displayed and the disc
cannot be ejected. The unit is carrying out the recovery process. Do the following to eject
the disc:
(1) Press [POWER 8] on the main unit to switch to off.
If the unit doesn’t switch to off, reset the unit ( ➔ 66, “To restore the
unit if it freezes”).
(2) While the unit is off, press and hold [g] and [CH 1] on the main unit
at the same time for about 5 seconds. (Ejection may take extra time
depending on discs.) The disc may be defective. Try another disc.
• −
Cannot eject a disc. The unit is recording. • −
The unit may have a problem. Eject the disc as in (2) above. • −
Startup is slow. Startup takes time in the following situations:
A disc other than a DVD-RAM is inserted.
The clock is not set.
Immediately after a power failure or the AC power supply cord is
connected.
When the unit is connected with an HDMI cable.
•
–
–
–
–
−
A password screen appears
and you are unable to view or
record. If the unit starts receiving a broadcast with the set rating information,
a password screen appears and you will be unable to view or record.
Enter your password to continue. • 42
Time is incorrect after using
Auto Clock Setting. Try again. If the time is still incorrect, set the clock manually ( ➔ 38). • 57
Troubleshooting Guide