PYLE Audio HTS8100 User Manual

Page 2

Advertising
background image

2

Important notes for users in the
U.K.
Mains plug

This apparatus is fi tted with an approved 13
Amp plug. To change a fuse in this type of
plug proceed as follows:

1

Remove fuse cover and fuse.

2

Fix new fuse which should be a BS1362

5 Amp, A.S.T.A. or BSI approved type.

3

Refi t the fuse cover.

If the fi tted plug is not suitable for your socket
outlets, it should be cut off and an appropriate
plug fi tted in its place.
If the mains plug contains a fuse, this should
have a value of 5 Amp. If a plug without a fuse
is used, the fuse at the distribution board
should not be greater than 5 Amp.

Note: The severed plug must be disposed of to
avoid a possible shock hazard should it be
inserted into a 13 Amp socket elsewhere.

How to connect a plug

The wires in the mains lead are coloured with
the following code: blue = neutral (N),
brown = live (L).

As these colours may not correspond with the

colour markings identifying the terminals in
your plug, proceed as follows:
– Connect the blue wire to the terminal
marked N or coloured black.
– Connect the brown wire to the terminal
marked L or coloured red.
– Do not connect either wire to the earth
terminal in the plug, marked E (or e) or
coloured green (or green and yellow).

Before replacing the plug cover, make certain
that the cord grip is clamped over the sheath
of the lead - not simply over the two wires.

Copyright in the U.K.

Recording and playback of material may
require consent. See Copyright Act 1956 and
The Performer’s Protection Acts 1958 to
1972.

ATTENTION!

For Customer Use:

Read carefully the information located at the
bottom or rear of your DVD Home Theatre
System and enter below the Serial No. Retain
this information for future reference.

Model No. HTS8100

Serial No. _______________

Norge

Typeskilt fi nnes på apparatens underside.

Observer: Nettbryteren er
sekundert innkoplet. Den innebygde
netdelen er derfor ikke frakoplet
nettet så lenge apparatet er
tilsluttet nettkontakten.

For

å redusere faren for brann eller elektrisk

støt, skal apparatet ikke utsettes for regn eller
fuktighet.

Italia

DICHIARAZIONE DI CONFORMITA’

Si dichiara che l’apparecchio HTS8100, Philips
risponde alle prescrizioni dell’art. 2 comma 1
del D.M. 28 Agosto 1995 n. 548.

Fatto a Eindhoven

Philips Consumer Electronics

Philips, Glaslaan 2

5616 JB Eindhoven, The Netherlands

Advertising