PYLE Audio HTS8100 - Manual (Page 51)

51
English
Problem (USB/HDMI/Dock Station) Solution
Troubleshooting
(continued)
The contents of the USB fl ash
drive cannot be read.
Slow operation of the USB
fl ash drive.
No audio output from HDMI
connection.
No video output from HDMI
connection.
No picture after changing the
HDMI video resolution.
No video from iPod playback.
‘NONE DOCKED’ appears on
the display panel.
– The USB fl ash drive format is not compatible with this
unit.
– Drive is formatted with a different fi le system which is
not supported by this unit (e.g. NTFS).
– Large fi le size or high memory USB fl ash drive takes
longer time to read and display on the TV.
– You will not hear any sound from the HDMI output if
the source device is only DVI/HDCP (High-bandwidth
Digital Content Protection)-compatible.
– It is not possible to output SACD or copy-controlled
DVD-Audio sources from the HDMI connection.
– Make sure that the audio output setting is not turned
off. See ‘Setup Menu Options - { Audio Setup Page -
HDMI Audio }’ for details.
– HDMI connection can only be made to HDMI-
equipped devices with HDCP (High Bandwidth Digital
Content Protection). If you wish to connect to a DVI
connector (equipped with HDCP), you will need a
separate adaptor (DVI to HDMI).
– Make sure the resolution of this unit matches the
device you have connected using the HDMI. See
‘Setup Menu Options - { Video Setup Page - HDMI
Setup - HDMI Video }’ for details.
– Your TV cannot support the current HDMI video
resolution. Switch the HDMI video resolution to the
next setting by holding down the SELECT/PROGRAM
on the remote control for more than 3 seconds
repeatedly until the picture appears on the TV again.
– Make sure you have connected the 3.5mm video cable
from the docking station to your TV. Turn on your
TV to the correct video input channel.
– Turn on the ‘TV ON’ setting of the iPod.
– Remove the GoGear/iPod from the docking cradle
and reinsert again.
– If the battery level of your GoGear/iPod is totally
drained, you have to charge it again before use.