Piega P Sub 4 - Manual (Page 10)

10
The power amplifiers of some manufacturers feature separate MAIN IN and PRE OUT terminals, allowing the preamplified signal to
reach the subwoofer and to be looped back again filtered. In this way the loudspeakers are relieved in the deep range, thus gaining
in precision and sound characteristics (see page 13). Refer to the appropriate manual for information about operation and connection
options for your power amplifier.
PIEGA P SUB 4
Configuration example for stereo mode
Stereo System with power amplifier featuring MAIN IN/PRE OUT loop
Connecting the System
Connection:
>Connect the P SUB 4 cable to the amplifier terminal marked
PRE OUT (or similar) and to the subwoofer terminal marked INPUT
>Connect the P SUB 4 cable to the amplifier terminal marked
MAIN IN (or similar) and to the subwoofer terminal marked OUTPUT
>For this use two connection cables with cinch plugs
(not supplied with the loudspeakers)
>Connect the front, rear and center loudspeakers using the
loudspeaker terminals provided on your AV receiver
Benefit:
Preferred configuration in the high end range
>The loudspeakers are relieved in the deep bass range...!
INPUT
OUTPUT
R L LINE
PRE OUT MAIN IN
L
R
Right Left
Front
Speaker R
Front
Speaker L
Amplifier