Piega P Sub 4 - Manual (Page 9)

Connecting the System
PIEGA P SUB 4
Configuration example for stereo and surround mode
Dolby Digital System - Surround System with NF Out
The 5.1 receivers and power amplifiers of some manufacturers have a separate NF Out socket for connecting a subwoofer. This
enables the signal to reach the subwoofer without any amplification. Refer to the appropriate manual for information about operation
and connection options for your AV receiver/power amplifier.
Note:
Frequently used configuration
>Ideal configuration for stereo mode...!
Connection:
>Connect the P SUB 4 cable to the AV receiver
terminal marked PRE OUT (or similar)
>Connect the P SUB 4 cable to the subwoofer
terminal marked INPUT
>For this use connection cables with cinch plugs (not supplied)
>Connect the loudspeakers using the loudspeaker terminals
provided on your AV receiver/power amplifier
9
INPUT
OUTPUT
R L
LFE / IN
LINE
PRE OUT
R
L
Right Left
230V T3. 15AL250V FOR 230V INPUT T5AL250V FOR 115V INPUT 115/230V - 50/60HZ 500W
Front
Speaker R
Front
Speaker L
Center
Speaker
Rear
Speaker R
Rear
Speaker L
Amplifier