Pioneer VSX-1121-K - Manual (Page 57)

En 57
10 Controlling the rest of your system
3 If necessary, press the input function
button for the component whose
command you want to input.
This is only necessary if the command is for a
new component (input function).
4 Select the button for the command
you want to input.
The LED blinks once and flashes continuously.
! You don’t need to program the receiver to
switch on or off. This is done automatically.
With Pioneer components, you don’t need to
program the power to switch off in a shutdown
sequence (except DVD recorders).
5 Repeat steps 3 to 4 to program a
sequence of up to five commands.
If you press RCU SETUP before programming is
completed, commands programmed up to that
point will be stored.
6 Press RCU SETUP to exit the
programming mode.
Using multi operations
1 Press MULTI OPERATION.
Release the button after the LED flashes once.
The LED continues to flash.
2 Within five seconds, press an input
function button that has been set up with
a multi operation.
The receiver switches on (if it was in standby)
and the programmed multi operation is per-
formed automatically.
Using System off
1 Press MULTI OPERATION.
Release the button after the LED flashes once.
The LED continues to flash.
2 Within five seconds, press u SOURCE.
The command sequence you programmed will
run, then all Pioneer components will switch
off, followed by this receiver (switch of all the
zones becomes off).
! In order to avoid accidently switching off a
DVD recorder that is currently recording, no
DVD recorder power off codes are sent.
Erasing the settings for the
multi-operation
This erases all the settings programmed in the
remote control for the multi-operation.
1 Press and hold RCU SETUP, then press
‘8’ for three seconds.
Release the button after the LED flashes once.
The LED continues to flash.
! To cancel the preset setup mode press
RCU SETUP.
2 Press the input function button
containing the program you want to
cancel or the u SOURCE button for three
seconds.
If the LED lights for one second, the erasing has
been successfully completed.
Resetting the remote control
settings
Use this procedure to reset all the remote con-
trol’s settings to the factory default.
! When preset codes are set, all the signals
learned in the input function buttons are
cleared. This function is convenient when you
want to reset some but not all of input function
buttons.
1 Press and hold RCU SETUP, then press
‘0’ for three seconds.
Release the button after the LED flashes once.
The LED continues to flash.
2 Press and hold the ENTER button for
three seconds.
If the LED lights for one second, the erasing has
been successfully completed.
Default preset codes
Input function button Preset code
DVD 2158
BD 2160
DVR/BDR 2150
HDMI 2159
TV/SAT 0116
CD 5066
TV CTRL 0116