Pioneer VSX-1121-K - Manual (Page 78)

En 78
13 Additional information
Symptom Remedy
HDCP ERROR shows in the
display. Check whether or not the connected component is compatible with HDCP. If
it is not compatible with HDCP, reconnect the source device using a different
type of connection (component or composite). Some components that are
compatible with HDCP still cause this message to be displayed, but so long as
there is no problem with displaying video, this is not a malfunction.
When Control with HDMI is
set to ON, the TV/SAT input’s
HDMI Input assignment is
canceled. Even when Control with HDMI is set to ON, the HDMI input is assigned for
the BD, DVD, DVR/BDR and VIDEO inputs regardless of the Control with
HDMI setting, so use these terminals.
Synchronized operation not
possible using Control with
HDMI function. Check the HDMI connections.
The cable may be damaged.
Select ON for the Control with HDMI setting (see HDMI Setup on page 45 ).
Select ALL for the Control Mode with HDMI setting (see HDMI Setup on page
45 ).
Turn the TV’s power on before turning on this receiver’s power.
Set the TV side Control with HDMI setting to on (see TV’s operating instruc-
tions).
HDMI
Symptom Remedy
The HDMI indicator blinks
continuously. Check all the points below.
No picture or sound. This receiver is HDCP-compatible. Check that the components you are con-
necting are also HDCP-compatible. If they are not, please connect them using
the component or composite video jacks.
Depending on the connected source component, it’s possible that it will not
work with this receiver (even if it is HDCP-compatible). In this case, connect
using the component or composite video jacks between source and receiver.
If the problem still persists when connecting your HDMI component directly to
your monitor, please consult the component or monitor manual or contact the
manufacturer for support.
If video images do not appear on your TV, try adjusting the resolution, Deep
Color or other setting for your component.
While analog video signals are being output over HDMI, use a separate con-
nection for audio output.
To output signals in Deep Color, use an HDMI cable (High Speed HDMI
®
Cable) to connect this receiver to a component or TV with the Deep Color
feature.
No picture. Try changing the Resolution setting (in Setting the Video options on page 50 ).
No sound, or sound suddenly
ceases. Check that the HDMI Audio setting is set to AMP (Setting the Audio options
on page 48 ).
If the component is a DVI device, use a separate connection for the audio.
If analog video is being output over HDMI, please use a separate connection
for the audio.
Check the audio output settings of the source component.
HDMI format digital audio transmissions require a longer time to be rec-
ognized. Due to this, interruption in the audio may occur when switching
between audio formats or beginning playback.
Turning on/off the device connected to this unit’s HDMI OUT terminal during
playback, or disconnecting/connecting the HDMI cable during playback, may
cause noise or interrupted audio.
Noisy or distorted picture. Sometimes a video deck may output a noisy video signal (during scanning, for
example), or the video quality may just be poor (with some video game units,
for example). The picture quality may also depend on the settings, etc. of your
display device. Switch off the video converter and reconnect the source and
display device using the same type of connection (component or composite),
then start playback again.
If the problem still persists when connecting your HDMI component directly to
your monitor, please consult the component or monitor manual or contact the
manufacturer for support.