Pioneer VSX-AX10Ai-G - Manual (Page 30)

Controls and displays 03
30
En
Display
1 SIGNAL indicators (page 74)
Light to indicate the currently selected input signal.
AUTO lights when the receiver is set to select the input
signal automatically.
2 Program format indicators
These change according to which channels are active in
Dolby, DTS, DVD-A and SACD sources.
LS, S and RS will light at the same time to indicate
6.1channel sources.
• L – Left front channel
• C – Center channel
• R – Right front channel
• LS – Left surround channel
• S – Surround channel (mono)
• RS – Right surround channel
• LFE – Low frequency effects channel
3 ((( )))
Lights when an LFE signal is being input.
4 Analog level indicators
OVER indicator
Lights when an analog input signal is too high,
risking distortion. Use the input attenuator to reduce
the level.
ATT indicator (page 75)
Lights when the input attenuator is on.
5 Character display
6 Digital format indicators
• – Lights when a Dolby Digital signal is
detected.
• – Lights when a DTS signal is detected.
• – Lights when one of the Home THX modes is
selected.
• – Lights during Surround EX matrix processing.
• – Lights when a decoding DTS-ES audio.
• – Lights during DTS-ES discrete processing.
• – Lights during DTS-ES matrix processing.
• – Lights during Dolby Pro Logic II and
Pro Logic IIx processing.
• – Lights during Neo:6 processing with 2-
channel sources.
• – Lights during two-channel
playback.
7 Speaker indicators
Light to indicate the current speaker system, A and/or B.
8 TAPE 2 (page 74)
Lights when the TAPE 2 monitor is switched on.
9 Tuner indicators
STEREO (page 54)
Lights when listening to a stereo FM broadcast in
auto/stereo mode.
TUNED
Lights when tuned to a broadcast.
MONO (page 54)
Lights when the tuner MPX mode is set to mono.
DIGITAL
PRO LOGIC
2ch PLAYBACK
DISC MTRX
Neo :6
OVER ATT
RDS RF ATT
TUNED STEREO MONO
SP AB
L
LFE
TAPE 2
C R
L S S R S
E N O
SIGNAL
AUTO
RF
DIGITAL
ANALOG
1 2 5 6 3 4
7 8 9
DIGITAL
DISC
MTRX
PRO LOGIC
Neo :6
2ch PLAYBACK