Pioneer VSX-AX10Ai-G - Manual (Page 78)

Using other functions 09
78
En
Checking your system settings
Use the status display screen to check the various
settings you’ve made for features such as sound delay,
digital noise reduction, and high-sampling.
1 From the remote control receiver menu, press
STATUS to check the system settings.
You may need to press on the Home menu ( )
first before reaching the receiver menu screen shown
below (use the
/ (cursor left/right) soft keys to go to
the previous/next menu screen).
These appear on both the OSD and the front panel
display.
The front panel display shows each of the following
settings for two seconds each:
Note
• If the Stream Direct mode is switched on, some
settings above will show OFF, even though they are
switched on.
2 When you’re finished, press STATUS again to
switch off the display.
Resetting the system
Use this feature to reset the system to its factory default
settings (see
Default receiver settings below).
1 Switch the receiver into standby.
2 While holding down the front panel DIGITAL NR
button, press and hold STANDBY/ON for about
three seconds.
The display shows
RESET?.
3 Press the front panel OPTION + button.
The display shows OK?.
4 Within 5 seconds, press OPTION –.
The receiver should now be reset.
Note
• This doesn’t affect the presets that you have
programmed into the remote control (see Using the
remote control with other components on page 66).
See
Resetting the remote control on page 10 to do
this.
Default receiver settings
The table below shows the factory default settings. When
you reset the system, the receiver reverts to these
defaults:
Surround back speaker/
Virtual back speaker Video select
Acoustic calibration EQ Dual mono
Digital noise reduction Sound delay
Midnight Hi-bit
Loudness High-sampling
Tone Real phantom
RECEIVER
RECEIVER 3/3
SB CH
MODE
INPUT
STATUS
INPUT
ATT
SPEAKER
A/B
VIDEO
SELECT
TAPE2
MONITOR
DISPLAY
DIMMER
RECEIVER
TV
CONT
SB CH MODE :
ACOUS. CAL EQ :
DIGITAL NR :
MIDNIGHT :
LOUDNESS :
TONE CONTROL :
VIDEO SELECT :
DUAL MONO :
SOUND DELAY :
HI-BIT :
HI-SAMPLING :
REAL PHANTOM :
ALL ADJ
OFF
ON
DVD/LD
CH1
0.0frame
OFF
OFF
OFF
OFF
OFF
OFF
Setting type Default setting Page ref.
Input DVD/LD
Master volume – – – dB (no sound)
Listening mode STANDARD (video inputs,
multichannel inputs, USB)
STEREO (audio inputs) page 41
Advanced surround
effect level 90 (5/7CH STEREO)
50 (all other modes) page 43
Listening mode (w/
headphones) STEREO page 44
Stream Direct mode SD:1 NORMAL (ON) page 45
Acoustic Calibration
EQ OFF (switches to ALL CH ADJ
after the Auto Surround Setup) page 46
Input signal select AUTO except multichannel
inputs (
ANALOG) and USB
( DIGITAL)
page 46
USB / multichannel
input channel setting 8 channels page 47
Surround Back
Channel mode ON (with surround back
speaker(s) connected) page 48
Virtual Surround Back
mode OFF page 49
Hi-bit/Hi-sampling OFF page 50