Planet Technology 802.11g Wireless ADSL 2/2+ Router ADW-4401A/Bv2 - Manual (Page 32)

32
Connection Setting: For PPPoE/PPPoA connection, you can select Always on or
Connect on-demand. Connect on demand is dependent on the traffic. If there is no
traffic (or Idle) for a pre-specified period of time, the connection will tear down
automatically. And once there is traffic send or receive, the connection will be
automatically on.
IP Address: For PPPoE/PPPoA connection, you need to specify the public IP address
for this ADSL Router. The IP address can be either dynamically (via DHCP) or given
IP address provide by your ISP. For Static IP, you need to specify the IP address,
Subnet Mask and Gateway IP address.
NAT: Select this option to Activate/Deactivated the NAT (Network Address
Translation) function for this VC. The NAT function can be activated or deactivated
per PVC basis.
[Dynamic Route]
RIP (Routing Information Protocol): Select this option to specify the RIP version,
including
RIP1, RIP2-B and RIP2-M. RIP2-B & RIP2-M are both sent in RIP-2 format,
the difference is that RIP2-M using Multicast and RIP2-B using Broadcast format.
RIP Direction: Select this option to specify the RIP direction. None is for disabling the
RIP function.
Both means the ADSL Router will periodically send routing information
and accept routing information then incorporate into routing table. IN only means the
ADSL router will only accept but will not send RIP packet. OUT only means the ADSL
router will only sent but will not accept RIP packet.
[Multicast]
IGMP (Internet Group Multicast Protocol): It is a session-layer protocol used to
establish membership in a multicast group. The ADSL supports both IGMP version
IGMP-v1 & IGMP-v2. Select None to disable it.
Your ISP should provide the above information. Note that you must enter the user
name exactly as your ISP assigned it. If the assigned name is in the form of
user@domain where domain identifies a service name, enter it exactly as given.