Planet Technology 802.11g Wireless ADSL 2/2+ Router ADW-4401A/Bv2 - Manual (Page 52)

52
and Many-to Many No-Overload .
Local Start & End IP: Enter the local IP address you plan to map to. Local Start IP
is the starting local IP address & Local End IP is the ending local IP address. If the
rule is for all local IPs, then the Start IP is 0.0.0.0 and the End IP is 255.255.255.255.
Public Start & End IP: Enter the Public IP Address you want to do NAT. Public
Start IP is the starting Public IP Address and Public End IP is the ending Public IP
Address. If you have a Dynamic IP, enter 0.0.0.0 as the Public Start IP.
When you are done making changes, click on SAVE to save your changes, DELETE
to delete the rule with the parameters you set, BACK to return to the previous screen or
CANCEL to exit without saving.
3.10.2 ADSL Type Setting
Go to Advanced Setup ->ADSL to set different ADSL connection
Select this option to set ADSL Mode and ADSL Type information.
ADSL Mode: Select which mode your ADSL connection uses from the dropdown
list.
The option has Auto Sync-up, ADSL2+, ADSL2, G.DMT, T1.413, G.LITE
ADSL Type: Select the ADSL type you use from the dropdown list.
ANNEX A, ANNEX I, ANNEX A/L, ANNEX M, ANNEX A/I/J/L/M
When you are done making changes, click on SAVE to save your changes.
When you are done making changes, click on SAVE to save your changes.
ʳ