Product features, Safety device, Piezo ignition system – Procom ML150TPA User Manual

Page 3: Thermostatic heat control on thermostat models, Local codes, Unpacking, Water vapor: a by-product of unvented room heaters

Advertising
background image

3

PRODUCT FEATURES

SAFETY DEVICE

A standard requirement for all vent-free room
heaters. This heater has a pilot with an Oxygen
Depletion Sensor(ODS) safety shutoff system.
The ODS/pilot shuts off the heater if there is
not enough fresh air.

PIEZO IGNITION SYSTEM

This heater is equipped with a piezo ignitor.
This system requires no matches, batteries, or
other sources to light heater.

THERMOSTATIC HEAT
CONTROL ON THERMOSTAT
MODELS

These heaters have a control valve with a
thermostat sensing bulb. This results in the
greatest heater comfort and may result in
lower gas bills.

LOCAL CODES

Install and use heater with care. Follow all local
codes. In the absence of local codes, use the
latest edition of National Fuel Gas code ANSI Z223.1,
also known as NFPA 54*.
*Available from :
American National Standards Institute, Inc.

1430 Broadway

New York, NY 10018

National Fire Protection Association, Inc.

1 Batterymarch Park

Quincy, MA 02269-9101

Figure1-Vent-Free Propane/LP Gas Heater

UNPACKING

1. Remove heater from carton.
2. Remove all protective packaging applied to
heater for shipment.
3. Check heater for any shipping damage. If heater
is damaged. promptly inform dealer where you
bought heater.

Water vaporis a by-product of gas combustion.An

unvented room heater productes approximately one (1)

ounce (30ml) of wter for every 1,000 BTU’s (.3KW’s) of

gas input per hour.

Unv ented room heaters are rec om mended as

supplemental heat (a room) rather than a primary heat

source (an entire house) .In most supplemental heat

application, the water vapor does not create a problem.

In most applications, the water vapor enhances the low

humidity atmosphere experience during cold weather.

WATER VAPOR: A BY-PRODUCT OF UNVENTED ROOM HEATERS

The following steps will help insure that water vapor

does not become a problem.

1. Be sure the heater is sized properly for the

application, including ample combusion air and

circulation air.

2. If high humidity is experienced, a dehumidifier may

be used to help lower the water vapor content of the

air.

3. Do not use an unvented room heater as the primary

heat source.

Advertising
This manual is related to the following products: