Plasmon 800-102913-00 B - Manual (Page 17)

Plasmon AA Express User Manual Hardware Installation
Document Revision B Page 15
Rack Mount Installation
The Archive Appliance Express can be rack mounted using a sliding rail kit available from Plasmon.
The rack mount kit works in racks with a depth of 22" to 34" (56 to 142 cm) from front to back rails.
Figure 5. Rack Mounting Kit for AAE
To install the rack mounting rails, perform the following steps:
1. Separate the sliding rail from the fixed rail by fully extending the sliding rail and releasing
the stop latch shown below. Repeat for the other rail.
2. Attach the sliding rails to the sides of the AAE by inserting the notched ends of the sliding
rails into the raised tabs toward the front on each side of the AAE, and attaching the rails
with two M4, 12mm x 20 screws on each as shown below.
Short L Brackets Long L Brackets
Sliding Rail Fixed Rail
Push up to release
sliding rail.
Mounting Screws Notched End