Plasmon 800-102913-00 B - Manual (Page 20)

Hardware Installation Plasmon AA Express User Manual
Page 18 Document Revision B
Cable Connections
Figure 7. Cable Conections
Power Connection
Route the power cable to the power connector located at the the back of the appliance.
The power cable can be plugged into a standard 120 volt to 240 volt wall outlet. The appliance uses an
auto-ranging power supply.
Do not use an extension cord. The unit must be located next to the AC outlet, and the outlet must be
easily accessible. In the event an emergency power cutoff is required, pull the plug from the AC socket.
Network Connection
Connect an ethernet network cable to the Ethernet 0 connector. The second Ethernet 1 connector can
be used for load balancing or fail over protection. By default, Ethernet 1 is disabled.
Ethernet 0
Connector Ethernet 1
Connector AC Power
Connector
Power On/Off Button
Diagnostics
Connector