Premio Computer Premio Apollo/Shadowhawk Computer - Manual (Page 74)

CHAPTER 3 AMI
®
BIOS USER’S GUIDE
3-13
Standby Time Out (Minute)
This option specifies the length of a period of system inactivity
while in Standby state. When this length of time expires, the computer
enters Suspend power state. The settings are Disabled, 1 min, 2 min, 4 min,
8 min, 10 min, 20 min, 30 min, 40 min, 50 min or 60 min.
Keyboard & PS/2 Mouse/
FDC/LPT/COM Ports/
SB & MSS Audio Ports/
MIDI Ports/
ADLIB Ports/
Primary Master IDE/Primary Slave IDE/Secondary Master
IDE/Secondary Slave IDE/System Thermal
When set to Monitor, these options enabled event monitoring on
the specified hardware interrupt request line. If set to Monitor and the
computer is in a power saving state, AMI BIOS watches for activity on the
specified IRQ line. The computer enters the full on power state if any
activity occurs.
AMI BIOS reloads the Standby and Suspend time out timers if
activity occurs on the specified IRQ line.
Power Button Function
During Suspend, if you push the switch once, the system goes
into suspend mode and if you push it more than 4 seconds, the system will
be turned off. During On/Off, the system will turn off once you push the
switch.
Restore on AC/Power Loss
The settings are power on, power off or last state. During power
on, after every AC power loss, the system will be turned on. During last
status, after every AC power loss, whatever the system status, it will be the
same when the AC power returns. During power off, after every AC power
loss, the system will be turned off.