Panasonic PV-DF204 - Manual (Page 33)

33
VC
R
Op
erat
ion
Set to see a recording over and over.
To turn “ON”
Press PLAY/REPEAT on the unit repeatedly
in Play mode to select “REPEAT ON.”
• Playback repeats when tape end is reached or
an unrecorded portion longer than 30 seconds is
detected.
• For repeat play in disc mode, see pages 54-57.
To quickly return to a specific tape counter
location.
4 Press STOP.
3 Continue to record, playback etc.
2 Press COUNTER RESET at the
desired position to reset to “0:00:00.”
1 Press DISPLAY during playback to
display the Counter.
5 Press CM/ZERO in Stop mode to
start ZERO SEARCH.
• Unit will go into FF or REW mode and stops
at the last point the Counter was set to
0:00:00.
Press CM/ZERO repeatedly to select skip
time in Playback mode.
By pressing the CM/ZERO button in
Playback mode you can skip over 1, 2, or 3
minutes of recorded tape as desired.
• No indication appears.
2 Press AUDIO repeatedly (each press
within 5 seconds) to select desired
mode.
• Select “HIFI (L/R),” to listen to a regular Hi Fi
Stereo recording. Select “HIFI (L)” or “HIFI
(R)” to listen only to the left or right channel of
a stereo recording. This is commonly used for
Karaoke, music on one channel and vocal on
the other. Select “NORMAL” for linear stereo
playback from a recorded tape with Hi Fi
disabled.
• This screen appears when you press AUDIO
during playback.
1 See the “Playback a Tape” section
on page 30 to playback the tape.
Choose the type of sound track for playback.
PLAY
REPEAT ON
PLAY 12:00PM
0:00:00
SLP
HIFI(L/R)
HIFI(L)
HIFI(R)
NORMAL
Repeat Play
Zero Search
Audio Mode for Playback
Commercial Skip
Notes
To turn “OFF”
Repeat above to select “REPEAT OFF.”
1st Press
1 min skip
OFF
2nd Press
2 min skip
3rd Press
3 min skip