Panasonic PV-DF204 - Manual (Page 65)

65
Dis
c
Op
erati
o
n
• When appears on the screen while a button is being pressed, it means that the
corresponding operation is prohibited by the unit or the disc.
8 Press ACTION to redisplay DVD
MAIN MENU and go to step 4 to set
up another item. Or, press ACTION
three times to exit.
DRC (Dynamic Range
Compression)
OFF:
Normal audio range is selected. (Factory
preset)
ON:
For dynamic sound even at low volume.
This is useful for late-night listening.
[Dolby Digital DVDs only].
• Make settings according to amplifier
connected to optical audio output as shown
in above table.
Type of
amplifier to
be
connected
Recommended setting
LPCM
(DVD) Dolby
Digital
dts
No amplifier
is connected
AV amplifier
without
Dolby
Digital/dts
decoder
PCM PCM* 1 PCM* 1
AV amplifier
including
Dolby Digital
decoder
PCM Bitstream* 3 PCM
AV amplifier
including
Dolby
Digital/dts
decoder
PCM Bitstream* 3 Bitstream* 2
Note
4 Press ▲▼ to select “STILL MODE.”
5 Press SET repeatedly for mode.
Set to reduce jitter in a displayed still picture
or a motion picture.
MAIN MENU
DVD LOCK LANGUAGE
TV CLOCK CH
SELECT: SET:SET
END :ACTION
DVD MAIN MENU
DISC LANGUAGES
AUDIO OUTPUT
STILL MODE :AUTO
TV MODE :4:3 Pan&Scan
SELECT :
SET :SET
END :ACTION
Selecting STILL MODE
DVD-V
1 Press ACTION in Stop mode to
display MAIN MENU.
2 Press ▲▼◄► to select “DVD.”
3 Press SET to display DVD MAIN
MENU.
AUTO:
“FIELD” (Field still) or “FRAME” (Frame
still) is automatically selected during the
still mode. (Factory preset)
6 Press ACTION twice to exit this
mode.
Field:
“FIELD” (Field still) is always selected.
This setting will reduce jitter when
compared with “AUTO” on some discs.
Frame:
“FRAME” (Frame still) is always selected.
Some texts and fine patterns will be seen
clearly when compared with “AUTO” on
some discs.
* 1 When connecting an amplifier (with an
optical digital input connector) which does
not contain the Dolby Digital or dts decoder,
be sure to select “PCM.” If “Bitstream” is
selected, starting DVD play may cause
such a high level of noise as to be harmful
to your ears and damage the speakers.
* 2 When a dts decoder is connected, please
select “Bitstream” in “dts.” If “PCM” is
selected, there will be stereo sound.
* 3 When a Dolby Digital decoder is connected,
please select “Bitstream” in “Dolby Digital.”
If “PCM” is selected, there will be stereo
sound.