Piega AP 3 - Manual (Page 7)

Thanks to their asymmetric design and well thought-out fixing concept, the AP 3, AS 3 loudspeakers can be used easily as wall,
center or ceiling loudspeakers. Refer to the alignment instructions on page 16 and use the pull-out drilling template provided at the
center of this user manual for mounting the wall and ceiling brackets.
PIEGA AP 3, AS 3
Positioning and mounting instructions...
On-Wall Installation
7
Mounting the wall bracket:
>Depending on the application, mark the holes for the wall bracket
horizontally or vertically, taking into account the optimum distances
required (stereo triangle)
>With concrete or brick walls, drill the holes with a 6 mm diameter and
use the screw anchors and screws supplied
>Only use suitable screws and screw anchors with wooden or
plasterboard walls (not supplied with the delivery)
Mounting the loudspeaker:
>Ensure without fail that the plastic washers are fitted inside the two
arms before inserting the loudspeakers
>Remove the two fixing screws on the upper and lower side
of the loudspeakers
>Position the loudspeaker carefully between to two arms of
the wall bracket
>Use the previously removed fixing screws supplied and insert
them from the outside
>Align the loudspeakers as required and tighten the screws evenly
>Connect the loudspeaker cables using the loudspeaker terminals
provided (see page 9)