POSIFLEX Business Machines PST - 7700 - Manual (Page 16)

Part 16
choose for “PM Wake Up Events” in “Power Management Setup” and make
the “Ring Power Up Control” enabled for Modem Ring Up or select the
“Power Up by Alarm” for Alarm Clock Wake Up. Save the configuration and
exit the CMOS setup program. The Preset Power On Control will then be
ready. For LAN wakeup, an operating caller system connected through LAN to
the system is required. It also requires a qualified networking technician to
check the LAN chip ID of the system for the caller system to wake up.
When the PST7700 system is turned off after a successful boot up, the
preset automatic power on functions will keep monitoring for the preset
conditions and turn on the system when the preset conditions are met.
Please note that if the PST7700 system is improperly turned off
before a complete boot up procedure, the above preset power on control
functions will be disabled until next turning off after a complete boot up.
Emergency Power Off
In case of serious system halt due to any reason, the system could fail
to be powered off through normal means. Press and hold the Power ON/OFF
Switch for Emergency Power Off. Release the switch after the system powered
off. It will take about 4 seconds if no power management kit installed and it
takes about 10 seconds if the option installed. If there appears to give a special
coded beep tone in the pattern “short, long, short, long, short” prior to the
system power off in this process, please remove the AC power and wait for
few minutes to allow the hardware registers to reset (If there is no such beep,
AC removal is not required). Then you may restart the system and take
remedial action against the precious failure.
CRT MONITOR (for PST7700/PST7730)
Mechanical Adjustments
The PST terminal has been designed with a novel support for the
monitor. Beside the usual tilt and swivel mechanism, this terminal has
incorporated “slide” capability so that the monitor position may be fully
adjusted. At all times the monitor is firmly supported on the display platform,
this gives a stable wobble free image and an absence of mechanical damage.
Display Controls
There are 1 power ON/OFF switch and 2 control knobs at front and
adjustment holes for V-size, H-phase and focus at rear.
Display Utility Driver
The end user of the PST terminals is not supposed to install the utility
drivers personally. If an optional preloaded OS is ordered, the required driver
will be already installed in the preloaded OS. However, the driver will always
be available over our web site: http://www.posiflex.com