POSIFLEX Business Machines PST - 7700 - Manual (Page 8)

Part 8
The next step is to
pass the monitor cable through
a square hole at the back edge
of main unit. Open the back
door by sliding two back door
latches at the bottom of back
door toward the center. The
back door is easily removable.
Remove the cable cover by
pulling the latch on the
underside of the cable cover
(ref. drawing below). Connect
the VGA cable to the VGA
connector through this opening
then put the cable cover back
onto the square hole with the hook
end in position first and then press
the cover down to position. You will
hear another click sound and the
cable cover is well mounted.
To remove the monitor, first
disconnect the cable then pull the
latch on the underside of the cable
cover to remove the cable cover.
Then pull the monitor hook lever at
rear bottom of the bowl by finger,
then raise and rotate the monitor forward till the CRT front is facing downward.
LCD CASHIER DISPLAY
When the PST7705 or
PST7735 is ordered, the user
has to take the 12.1” TFT LCD
cashier display out from the
cashier display carton and
assemble it onto the main unit
per following instructions.
Unscrew and take out
the pivot that is screwe d on the
display platform of the main
unit. Unfold the base of the
operator display and insert it
into the opening on the display
Monitor
Hook Mounting
Lugs
Mounting
Holes
Bowl
Cable Cover Latch
VGA Connector
Cable Cover
Base Of
LCD
Pivot
12.1” LCD