Pioneer DVH-P4100UB - Manual (Page 48)

3 Turn MULTI-CONTROL to select the lan-
guage.
EUROPEAN (European language)
—RUSSIAN
(Russian language)
# You can also perform the same operations by
pressing a or b.
4 Press MULTI-CONTROL to determine
the selection.
# Even if the menu has been canceled before
determination, operation is settled.
Setting the display connection
on or off
You can use this unit with or without the dis-
play. When using this unit connected to the
display, you can turn the display connection
setting on or off. If you turn this function on,
the detailed text information of the
DVD, USB
and USB-IPOD source appears on the display.
1 Use MULTI-CONTROL to select V.OUT in
the initial setting menu.
Refer to Adjusting initial settings on page 45.
2 Press MULTI-CONTROL to turn display
connection on.
# To turn display connection off, press
MULTI-CONTROL again.
Note
The operation of this unit differs according to the
display connection on/off setting. The examples
are as follows:
! Playing a compressed audio file and display-
ing the file name list mode
— When the display connection is set to on,
the files of the currently playing folder are
displayed.
— When the display connection is set to off,
the file of the root folder is displayed.
! Playing a compressed audio file and pressing
DISP/BACK/SCRL in the file name list
— When the display connection is set to on,
the name of the currently playing file is se-
lected.
— When the display connection is set to off,
you can return to the previous list (the
folder one level higher).
Correcting distorted sound
Only when the multi-channel processor (DEQ-
P6600) is connected to this unit, you can oper-
ate this function.
You can minimize distortion that may be
caused by the equalizer curve settings.
Setting an equalizer level high can cause dis-
tortion. If high sound is crippled or distorted,
try switching to
LOW. Normally, leave the set-
ting at HIGH to ensure quality sound.
1 Use MULTI-CONTROL to select
DIGITALATT in the initial setting menu.
Refer to Adjusting initial settings on page 45.
2 Press MULTI-CONTROL to display the
setting mode.
# Press DISP/BACK/SCRL to return to the pre-
vious display.
3 Turn MULTI-CONTROL to switch the di-
gital attenuator setting.
! HIGH – High quality sound
! LOW – Minimize distortion sound
# You can also perform the same operations by
pressing a or b.
4 Press MULTI-CONTROL to determine
the selection.
# Even if the menu has been canceled before
determination, operation is settled.
Resetting the audio functions
Only when the multi-channel processor (DEQ-
P6600) is connected to this unit, you can oper-
ate this function.
You can reset audio functions other than the
following settings.
! Volume setting (refer to Adjusting the vo-
lume on page 15)
! Listening position setting (refer to Using
the position selector on page 53)
Operating this unit
En
48
Section
02