Pandigital PI1051DWCB - Manual (Page 16)

16
Navigate the keyboard keys as follows:
ƒ Use the remote control buttons to highlight the keys, and then press ENTER ,
multiple times as needed, to select the desired characters
ƒ SYM = Access the following symbols:
\ / : ; ( ) $ & [ ] . , % ^ + = - | < > { } ! ~
ƒ NUM = Toggles between numeric and letter characters
ƒ ABC/abc = Toggles between upper and lower case letters
ƒ = Scroll through your entry to edit as needed
ƒ Backspace = Erases last selected character
ƒ Done = Completes entry
ƒ Cancel = Return to the previous screen without an entry
Note: You can also use the remote control buttons as follows:
‘ + ’ = Scroll forward
‘ - ‘ = Scroll back
ROTATE = Backspace, erases last selected character
ZOOM = Toggles between SYM / NUM / ABC / abc screens
Set up Wireless Network
Note: You must have an active wireless network within range of the DPF, and the Pandigital wireless Wi-Fi USB Adapter must be connected to the DPF. (Wi-Fi
adapter sold separately on our website: http://www.pandigital.net .)
1. Insert the Pandigital wireless USB adapter into the USB Host port on the DPF.
2. On the HOME screen, press MENU .
3. Select Wi-Fi Network Setup . The Network Setup window will be displayed, similar to this example:
4. Select Scan for Available Network. The wireless networks within range will appear in the Network Setup window.
5. Select the desired Wi-Fi network to which you want to connect. The network screen will be displayed, similar to this example:
TIP: If your wirless network is configured to be ‘hidden’, the scan will not list it as an available network. Select one of the Network SSID buttons to
manually enter the Network ID.
6. If necessary, change the Secure Access type by pressing ENTER on the option button multiple times to select the appropriate security type.
7. Select Password , and then use the virtual keyboard to enter your Wi-Fi Password . (The ID and password are case sensitive; use the ‘ABC/abc’ ‘NUM’
and ‘SYM’ keys as needed for correct characters.)
8. Select Done on the virtual keyboard.
9. Select Connect . Do not press any other keys until the connection completes (20-30 seconds).
A connection status message will be displayed, and then the MAC and IP address of the network to which you connected will be displayed.