Polk Audio DSWmicroPRO1000 - Manual (Page 6)

6 Polk Audio Customer Service 800-377-7655 (Outside USA & Canada: 410-358-3600)
CONNECTING THE SUBWOOFER TO
THE SYSTEM—HOOKUP OPTIONS
IMPORTANT NOTE: USE ONLY ONE OF THESE OPTIONS.
NEVER COMBINE HOOKUP OPTIONS.
OPTION #1 Receivers that include a “SUB OUT” feature—
the most common hookup method with Dolby Digital
® and DTS ® receivers.
• Connect a single RCA cable from the “SUB OUT” of your receiver to the LFE
input of the subwoofer. This connection method bypasses the subwoofer’s
internal filter and relies on the low-pass filter built into your receiver. Make
no other signal connections. Do not use speaker wire to make the
connection to the subwoofer.
• Connect all other speakers directly to the receiver. Adjust your receiver’s
speaker configurations as follows:
Front Speakers = SMALL
Center and Surrounds = SMALL
Subwoofer = ON, YES, or PRESENT
• Depending on your front speakers’ bass output capabilities, set the crossover
frequency on the receiver to 80Hz for tower and bookshelf speakers (speakers
with a woofer 5 1/4" in diameter or larger) and 100-120Hz for satellite
speakers. Consult your receiver’s owner’s manual for instructions.
OPTION #2 Two channel or Dolby PRO Logic ® receiver with no “SUB OUT.”
Use two-conductor 16 gauge or thicker speaker wires. See your Polk Audio
dealer for wire recommendations.
Note: Do not use the line or LFE input in this configuration.
• Connect the left and right front speaker outputs of your receiver to the
speaker level inputs of the subwoofer using speaker wire (see “Making
Binding Post/Speaker Wire Connections” for detailed instructions).
• Connect the left and right front speaker outputs of your receiver directly
to the speaker inputs of your front speakers.
• Connect the center channel speaker directly to the center channel output
from your receiver. (Not Shown)
• Connect the rear surround satellites directly to the rear or surround
channel outputs from your receiver. (Not Shown)
• Adjust your receiver’s speaker configurations as follows:
Front Speakers = LARGE
Center and Surrounds = SMALL
Subwoofer = OFF or NO
(Artwork not
to scale)
SUB OUT
SPEAKER IN
LINE
OUT
LINE
IN
POWER LOW PASS
40Hz
80Hz
120Hz
MIC
IN
VOL DOWN VOL UP
12V
TRIG
IR
12 V AUDIO SENSE ON R E M O T E CONTR OL (Artwork not
to scale)