Paradyne COMSPHERE 6700 SERIES - Manual (Page 16)

Workstation Settings
2-4 Issue 2 December 1996
Choosing the Active Server
Use Active Server... to choose the active server for the NMS
client. After you choose an active server with this command, the
NMS client uses the IP address you set up using NMS
Servers... to communicate with that server.
.
Procedure
1. Select Workstation from the Main Menu.
2. Choose Active Server.... The Active Server dialog box
appears, as shown in Figure 2-2.
Figure 2-2. Active Server Dialog Box
3. Select a server from the Available NMS Servers
listbox.
4. Choose OK. The Main Menu appears.
NOTE:
If you change the NMS server while the NMS is active,
you must restart NMS.